Nest assembly guide
Kit Contents
The nest assembly kit contains:
- The base of the module (with hydra insert for modules with the hydra system)
- 1 plexiglass window (except for the XS hydra module)
- 1 cap for the foundation and S modules, 3 caps for the other modules
- 1 hydra plug for modules with the hydra system
- 5 feet for the foundation module, 7 feet for the S module, 8 feet for the other modules
- As many 25mm screws as there are feet
- As many nuts as there are feet
Assembling a nest module takes about 5 minutes.
Do not use a screwdriver to mount a module; the force exerted would be too strong and could damage it.
Module assembly steps
Start by inserting the caps into the connection ports you want to close.
Insert the nuts into the legs.
Fit the feet into the slots provided for this purpose under the module.
Remove the protective films from both sides of the plexiglass window. The protective films may leave some dust on the glass. To remove them, you can use the sticky side of one of the protective films or a clean microfiber cloth.
Place the glass on the module, taking care to align the holes intended to receive the screws.
Insert the screws, then tighten them using a 2 mm Allen key.
If you are not using the module directly with the water reserve, place the cap on the hydra system to preserve the sponge.
The assembly is complete!
The module is ready to use.